ASTM B1032/B1032M : 25

Standard Guide for Melting Copper Granules (Choppings) to Cast a Test Block for Chemical Analysis and Copper Content Determination

Standard Details

1.1 In this guide, the key process steps are reviewed to melt a sample or designated sample portion, both of which are referred to as a sample in this guide, of copper granules (choppings) and cast a test block for laboratory analysis including determination of copper content of the sample.1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Information

Status : ACTIVE

Standard Type: Main

Document No: ASTM B1032/B1032M : 25

Document Year: 2025

Pages: 2

Section Volume:
02.01 Volume 02.01 Copper and Copper Alloys

Preview Document

Life Cycle

Currently Viewing

ACTIVE

ASTM B1032/B1032M : 25

ASTM B1032/B1032M : 25

Standard Details

General Information

Life Cycle

Add Standards To Trackedge

Enquiry Form